Difference between revisions of "MOT"
From WikiLEC
(Layout) |
|||
| Line 2: | Line 2: | ||
| − | + | * While it’s a good idea to do all the normal checks prior to an MOT – making sure there are no bulbs out, checking the items that only get used once a year, like the horn, windscreen washers and hazard warning lights – with the Élan you need add the brakes to the list. | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | They are better done | + | * They are better done in advance of the test. You’ll not only enhance the chances of it passing, but you’ll have the added benefit of a shorter stopping distance, for a while. |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | + | * For newcomers, all I did to get my rear brakes from a failure reading of 30 and 40 to a pass of 70 and 70 was to remove the pads - check the sliders were free – remove the central rubber plug from the piston to check the extent of any internal seal leaks - checked the pistons were free, the offside one turns anticlockwise/inwards (the information in the manual is looking from the back of the car) – clean the edges of the steel backing plates and the corresponding part on the callipers – take the glaze of the pads with sandpaper – and reassemble. | |
| − | + | * You can do the same thing at the front, but include changing the inner pad to the outside and visa versa. This will even out the wear and put the slider arrangement into a new position. | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | + | ---- | |
| − | + | ||
| − | [[ | + | * muley |
| − | [[ | + | |
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=9566&highlight=mot+failed To view a car's MOT history] | ||
| + | |||
| + | |||
| + | * RayD | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=9609&highlight=mot+failed Rear brakes inadequate] | ||
| + | |||
| + | |||
| + | * RichyP | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=11467&highlight=mot+failed All four brake discs] | ||
| + | |||
| + | |||
| + | * dapinky | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=9583&highlight=mot+failed Hazard light switch not illuminating] | ||
| + | |||
| + | [http://www.lotuselancentral.com/forum/viewtopic.php?t=10096 The solution is on this thread.] | ||
| + | |||
| + | * Gazza | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=10929&highlight=mot+failed Lower Steering UJ] | ||
| + | |||
| + | |||
| + | * Hinch | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=10628&highlight=mot+failed Broken headlight] | ||
| + | |||
| + | |||
| + | * kevincprice | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=5570&highlight=mot+failed Inner track rod end] | ||
| + | |||
| + | |||
| + | * nchase | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=10656&highlight=mot+failed The handbrake] | ||
| + | |||
| + | |||
| + | * martyn roberts | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=10366&highlight=mot+failed Emissions] | ||
| + | |||
| + | |||
| + | * Benmac | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=9876&highlight=mot+failed Front brakes ] | ||
| + | |||
| + | |||
| + | * Russc | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=9590&highlight=mot+failed Handbrake and Windscreen washer jets] | ||
| + | |||
| + | |||
| + | * davel | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=8921&highlight=mot+failed Heavy steering] | ||
| + | |||
| + | |||
| + | * pit_stop | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=8171&highlight=mot+failed All four brake discs] | ||
| + | |||
| + | |||
| + | * Andrew_Ennis | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=7560&highlight=mot+failed Nearside upper ball joint] | ||
| + | |||
| + | |||
| + | * Hinch | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=7245&highlight=mot+failed Condition of the rear disks] | ||
| + | |||
| + | |||
| + | * hec | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=7110&highlight=mot+failed Rear wishbones and FNS bottom arm] | ||
| + | |||
| + | |||
| + | * Ray | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=6641&highlight=mot+failed Horn] | ||
| + | |||
| + | |||
| + | * schurch | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=6481&highlight=mot+failed Rear braking effort] | ||
| + | |||
| + | |||
| + | * Stef | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=6020&highlight=mot+failed Rear brake discs and pads] | ||
| + | |||
| + | |||
| + | * PaulW | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=612&highlight=mot+failed Emissions] | ||
| + | |||
| + | |||
| + | * D3DSY | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=10126&highlight=mot+failure Dipped beam too high] | ||
| + | |||
| + | |||
| + | * hec | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=8539&highlight=mot+failure front brake hose] | ||
| + | |||
| + | |||
| + | * paulwatkins | ||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?t=9012&start=0&postdays=0&postorder=asc&highlight=gaiter Outer CV joint gaiter] | ||
| + | |||
| + | |||
| + | * Rushing | ||
| + | |||
| + | |||
| + | [http://lotuselancentral.com/forum/viewtopic.php?p=154718#154718 Rear Callipers] | ||
Latest revision as of 01:05, 18 May 2008
MOT Common Failures and Remedies
- While it’s a good idea to do all the normal checks prior to an MOT – making sure there are no bulbs out, checking the items that only get used once a year, like the horn, windscreen washers and hazard warning lights – with the Élan you need add the brakes to the list.
- They are better done in advance of the test. You’ll not only enhance the chances of it passing, but you’ll have the added benefit of a shorter stopping distance, for a while.
- For newcomers, all I did to get my rear brakes from a failure reading of 30 and 40 to a pass of 70 and 70 was to remove the pads - check the sliders were free – remove the central rubber plug from the piston to check the extent of any internal seal leaks - checked the pistons were free, the offside one turns anticlockwise/inwards (the information in the manual is looking from the back of the car) – clean the edges of the steel backing plates and the corresponding part on the callipers – take the glaze of the pads with sandpaper – and reassemble.
- You can do the same thing at the front, but include changing the inner pad to the outside and visa versa. This will even out the wear and put the slider arrangement into a new position.
- muley
- RayD
- RichyP
- dapinky
Hazard light switch not illuminating
The solution is on this thread.
- Gazza
- Hinch
- kevincprice
- nchase
- martyn roberts
- Benmac
- Russc
Handbrake and Windscreen washer jets
- davel
- pit_stop
- Andrew_Ennis
- Hinch
- hec
Rear wishbones and FNS bottom arm
- Ray
- schurch
- Stef
- PaulW
- D3DSY
- hec
- paulwatkins
- Rushing
