Hall Effect Sensor - Revision history

Geoff at 18:06, 17 May 2009

2009-05-17T18:06:00Z

2009-05-17T18:05:46Z

2009-04-01T23:51:34Z

Added fitting instructions from LEC forum

2008-05-10T17:37:52Z

2008-01-14T15:17:48Z

New page

[[Image:Hal.jpg]]

← Older revision		Revision as of 18:06, 17 May 2009
Line 1:		Line 1:
−	Part numbers A100E0102S and A100E6570L.	+	'''Part numbers A100E0102S and A100E6570L.'''

	Fitting the HES is a pretty easy job. From memory:		Fitting the HES is a pretty easy job. From memory:

@@ Line 1: / Line 1: @@
 Fitting the HES is a pretty easy job. From memory:
@@ Line 5: / Line 7: @@
 # remove the old HES & put on the new one (direct replacement with no fiddling). Adjust so that the metal trigger passes cleanly past the new HES.
 # put a new O-ring seal on the shaft if needed.
-# replace CAS (this can take a minute or two of fiddling to push the shaft with its new O-ring into the hole such that the peg on the end locates  properly)
+# replace CAS (this can take a minute or two of fiddling to push the shaft with its new O-ring into the hole such that the peg on the end locates properly)
 # cut off the old HES plug from the wiring loom, put the sealing plugs onto the wires, strip the ends, crimp the three wires into the new terminals (a bit fiddly), click the terminals into the new plug (double-check the colour codes on the wires match) and slide the seals down into the holes.
 # connect up the new plug to the new HES and reconnect the second CAS connector

← Older revision		Revision as of 23:51, 1 April 2009
Line 1:		Line 1:
		+	Fitting the HES is a pretty easy job. From memory:
		+
		+	# unplug the two connectors from the CAS (no need to mark them - they're different)
		+	# mark the position of the CAS, remove it and take off the black plastic cover.
		+	# remove the old HES & put on the new one (direct replacement with no fiddling). Adjust so that the metal trigger passes cleanly past the new HES.
		+	# put a new O-ring seal on the shaft if needed.
		+	# replace CAS (this can take a minute or two of fiddling to push the shaft with its new O-ring into the hole such that the peg on the end locates properly)
		+	# cut off the old HES plug from the wiring loom, put the sealing plugs onto the wires, strip the ends, crimp the three wires into the new terminals (a bit fiddly), click the terminals into the new plug (double-check the colour codes on the wires match) and slide the seals down into the holes.
		+	# connect up the new plug to the new HES and reconnect the second CAS connector
		+
		+	The only fiddly bits were crimping the terminals and locating the CAS back in the head correctly. It's not difficult. When I checked the static timing at the end, I found that whereas the timing mark alignment had been a bit wavery with the old HES, the strobe held the mark rock solid with the new HES.
		+
		+	[http://forum.lotuselancentral.com/viewtopic.php?f=85&t=4787&start=260#p193386 John_W]
		+
	[[Image:Hal.jpg]]		[[Image:Hal.jpg]]

	[[Category:Components]]		[[Category:Components]]