Difference between revisions of "ElanScan"
(→Communication errors) |
|||
| Line 2: | Line 2: | ||
ElanScan is available for download from [[http://www.astb91.dsl.pipex.com/M100_ALDL.html ESM's website]], information on obtaining or building suitable interfaces is also available at the same place. | ElanScan is available for download from [[http://www.astb91.dsl.pipex.com/M100_ALDL.html ESM's website]], information on obtaining or building suitable interfaces is also available at the same place. | ||
| + | |||
| + | == Preparation == | ||
| + | |||
| + | If you think you have a problem, CHECK THE [[BASE TIMING]]. Provided this is correct, then proceed. | ||
---- | ---- | ||
Revision as of 20:46, 18 August 2007
ElanScan is a piece of software which interfaces with the Elan's ECU and can retrieve various real-time stats.
ElanScan is available for download from [ESM's website], information on obtaining or building suitable interfaces is also available at the same place.
Preparation
If you think you have a problem, CHECK THE BASE TIMING. Provided this is correct, then proceed.
Communication errors
The error log reports any bad communications between the pc/ES and then car/ECU :
Comm port inactive - The wrong communications port has been selected for ElanScan. Check in the pc hardware configuration / device manager to see which ports are present. From bitter experience, this may also indicate a broken serial port!
Bad echo (sent: F4 56 01 B5: received: ) - The ECU is not responding, usually because the ignition is not turned on or the interfaces is not properly connected [Note F4 56 01 B5 relates to the Elan turbo engine only]
Bad echo (sent: F4 56 01 B5: received: XX XX XX XX) Indicates noisy communication with the ECU, likely caused by a poor electrical connection [Note XX is the hex representation of a byte of data and there may be between one and four bytes returned depending on the problem]
No reply No frame start byte recieved - Probably [TO BE CONFIRMED] caused by having the latency timer setting too high: In device manager, select | USB serial port | Port settings | Advanced | BM option | Latency timer (ms) | and set to 1. See also USB driver instructions.
